Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Lock the head adapter into the base body of the crimping
pliers by pushing in the pins -arrow-.
2.4 Repair of airbag and belt tensioner ca‐
bles
Note
♦
Observe the general instructions for the repair on the vehicle
electrics ⇒ i2.1 nstructions for the repair on the vehicle elec‐
trics”, page 41 .
♦
Observe the general instructions for the wiring loom and
plug repair ⇒ i2.2 nstructions for wiring harness and plug
repair ”, page 42 .
WARNING
Faulty repairs to the airbag and belt tensioner wiring loom
can lead to the malfunction of the occupant protection.
♦ Only use cables of the airbag and belt tensioner wiring
loom from the auxiliary measuring set, see ⇒ h2 arness
repair”, page 41 using original parts (socket housings,
plugs and cables see ⇒ Electronic Catalogue of Original
Parts “ETKA”).
♦ Do not carry out any repairs to the cables of the individu‐
al airbag units.
♦ In case of damage to the cables or plugs at the airbag
units, the related airbag units must be replaced for rea‐
sons of safety.
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
48 Rep. gr.97 - Wiring
To Next Page
Loading...
