Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Install air filter housing:
♦ Petrol engines ⇒ Rep. gr. 24; Air filter; Removing and instal‐
ling air filter housing.
♦ Diesel engines ⇒ Rep. gr. 23; Air filter; Removing and instal‐
ling air filter housing.
– Connect battery earth strap ⇒ Electrical system; Rep. gr. 27;
Battery; Disconnecting and connecting battery.
– Check the function of the ignition key anti-removal lock ⇒
t2.4 he gearshift mechanism”, page 120 .
– Setting selector lever control cable ⇒ a2.7 nd adjusting the
selector lever control cable”, page 141 .
– Inspect gearshift mechanism ⇒ t2.4 he gearshift mecha‐
nism”, page 120 .
Tightening torques and summaries of components
Note
Replace bolts/nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ o2.1 f components - Gearshift mechanism”, page 92
Component Tightening torque
Nuts for tunnel cross-pieces 20 Nm
2.3.3 Removing and installing shift mecha‐
nism without selector lever control ca‐
ble, Octavia III
Removing
– Removing selector lever handle ⇒ a2.8 nd installing selector
lever handle”, page 144 .
– With ignition switched off, disconnect battery earth strap
⇒ Electrical system; Rep. gr. 27; Battery; Disconnecting and
connecting battery.
– Remove centre console and air guide ⇒ General body re‐
pairs, interior; Rep. gr. 68; Centre console; Removing and
installing centre console.
– Disconnect plug connection for vehicle wiring harness to se‐
lector mechanism -1-.
Octavia III 2013 ➤, Octavia III 2014 ➤, Rapid NH 2013 ➤, Rapid NH 2014 ➤
Gearbox 0CW-DSG - Edition 07.2022
110 Rep. gr.34 - Controls, housing
To Next Page
Loading...
Need help?
General
