Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
The seal can only be inserted in one position.
– Insert new seal in the groove around the mechatronics.
• The tabs on the seal -bottom arrow- must cover the recess
on the mechatronics -top arrow-.
– Fill oil into the mechatronics ⇒ a7.2 nd top up hydraulic oil
for mechatronics”, page 233 .
– Install mechatronics ⇒ a1.2 nd installing mechatronics”,
page 59 .
Tightening torques and summaries of components
Note
Replace bolts/nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ Oil drain plug for mechatronics ⇒ o1.1 f components - me‐
chatronics”, page 56
1.5 Replace control unit for mechatronics
for dual clutch transmissions -J743-
Special tools and workshop equipment required
Octavia III 2013 ➤, Octavia III 2014 ➤, Rapid NH 2013 ➤, Rapid NH 2014 ➤
Gearbox 0CW-DSG - Edition 07.2022
1. Mechatronics 85
To Next Page
Loading...
Need help?
General
