Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
NOTICE
Risk of damage to the gearbox mount due to incorrect instal‐
lation of the gasket ring.
– Touch the gasket ring until flush to ensure the oil bore
underneath is not blocked In this case, the bearing is not
given a sufficient supply of oil.
– Using a plastic hammer, drive the new sealing ring flush with
the clutch housing, as shown in the illustration.
• The shoulder -arrow- on the pipe section -VW415A- points
upwards.
– Install release mechanism ⇒ a1.2 nd installing clutch engag‐
ing mechanism”, page 17 .
– Install double clutch ⇒ d2.3 ouble clutch”, page 44 .
2.5 Replace gasket ring for inner drive
shaft
Special tools and workshop equipment required
♦ Sealing ring extractor -T10420A-
Octavia III 2013 ➤, Octavia III 2014 ➤, Rapid NH 2013 ➤, Rapid NH 2014 ➤
Gearbox 0CW-DSG - Edition 07.2022
2. Clutch 53
To Next Page
Loading...
Need help?
General
