5-9
1-3. CAMERA SYSTEM ADJUSTMENTS
Before perform the camera system adjustments, check that the
specified value of “Composite Output Y Level Adjustment” and
“Composite Output Chroma Level Adjustment” of “Base band Block
Adjustment” of “VIDEO SYSTEM ADJUSTMENT” are satisfied.
1. 36 MHz Origin Oscillation Adjustment
(VC-206 board)
Set the frequency of the clock for synchronization. If deviated, the
synchronization will be disrupted and the color will become
inconsistent.
Subject Not required
Measurement Point Pin !§ of IC203 (CL200)
Measuring Instrument Frequency counter
Adjustment Page F
Adjustment Address 1C
Specified Value f=18000000 ± 180Hz (NTSC)
f=18000000 ± 126Hz (PAL)
Adjusting method:
1) Select page: 6, address: 00, and set data: 01.
2) Select page: F, address: 1C, change the data and set the clock
frequency (f) to the specified value.
3) Press the PAUSE button of the adjustment remote commander.
4) Select page: 6, address: 00, and set data: 00.
2. Zoom Key Center Adjustment (VC-206 board)
Set the A/D value center of the microprocessor to the center voltage
of the zoom key.
If deviated, the zoom lens operates of itself ,even if the zoom key is
the center position.
Subject Not required
Measurement Point Display data of page: 2, address: 63
Measuring Instrument of the adjustment remote commander
Adjustment Page D
Adjustment Address 5B
Specified Value The same data as page: 2, address: 63.
(The data should be “6D” to “93”.)
Note: Perform this adjustment when the operation switch block (FK-4580)
is replaced.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 2, address: 63, read the data, and this data is named
D63. (The data of address: 63 should be “6D“ to “93“.)
3) Select page: D, address: 5B, set data: D63.
4) Press the PAUSE button of the adjustment remote commander.
5) Select page: 0, address: 01, and set data: 00.
To Next Page
Loading...
Need help?
General
