北米Model "A3240BE-A" EDITED: 2022/ 7/ 29
Models with “keyless access with
push-button start system”:
If desired, you can turn the audible signal
off by operating the center information
display. For details, refer to “Car settings”
�P215. Furthermore, the volume setting
of the audible signal can also be changed
by a SUBARU dealer. Consult your
SUBARU dealer for details.
Models without “keyless access with
push-button start system”:
Perform the following steps to deactivate
the audible signal. Take the same steps to
restore the function.
Steps Operation Time
1 Sit in the driver’s seat. —
2
Close all doors and the
rear gate.
—
3
(1)
Press and hold “
” on
the power locking
switch.
Within
10 sec.
(2)
Insert the key into the
ignition switch and pull it
out at least 6 times.
4
Open and close the dri-
ver’s door.
Within
10 sec.
The hazard warning flashers flash 3 times
to indicate completion of the setting.
Your SUBARU dealer can perform the
above procedure for you.
& Replacing the battery
S02AE08
Refer to “Replacing key battery” �P516.
& Replacing lost transmitters
S02AE09
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), your transmit-
ters should be reprogrammed for security
reasons. For details, contact your
SUBARU dealer and have the transmitters
programmed into the remote keyless entry
system.
& Certification for remote key-
less entry system
S02AE18
! U.S.-spec. models
S02AE1801
FCC ID: CWTB1G077
FCC ID: CWTD1G141
CAUTION
FCC WARNING
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user’s authority to operate the
equipment.
NOTE
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This de-
vice may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
Remote keyless entry system
136
To Next Page
Loading...
Need help?
General
