北米Model "A3240BE-A" EDITED: 2022/ 7/ 29
& Hill descent control function
S07BI03
The hill descent control function will be in
standby mode when X-MODE is activated
and the vehicle speed is less than approxi-
mately 12 mph (20 km/h).
The function will operate when the vehicle
speed is less than approximately 12 mph
(20 km/h) and the accelerator ratio is less
than approximately 10%.
The function will turn off when the vehicle
speed is more than approximately 12 mph
(20 km/h) and the accelerator pedal is
depressed.
CAUTION
The braking power of the hill des-
cent control function may not be
sufficient when strong braking
power is needed (e.g., when towing
a trailer).
NOTE
. Even while the hill descent control
function is operating, you can vary
the vehicle speed using the brake
pedal or accelerator pedal.
. During braking by the hill descent
control function, the stop light will
illuminate.
. The hill descent control function is
operable regardless of the gradient
of the road.
. The hill descent control function
may be considered normal when
the following conditions occur.
– An operating sound is heard
briefly from the engine compart-
ment while the hill descent con-
trol function is operating.
– The sensation of depressing the
brake pedal is different, (harder
than usual etc.) when the brake
pedal is depressed during hill
descent control function opera-
tion.
! Hill descent control indicator
S07BI0301
This indicator appears while the hill des-
cent control function is in the standby
mode. It flashes while the function is
operating. It will disappear when the
function is in the disabled mode. When
this function is changed from operational
to non-operational, it will disappear when
the vehicle speed reaches more than
approximately 18 mph (30 km/h).
X-MODE
372
To Next Page
Loading...
Need help?
General
