北米Model "A3240BE-A" EDITED: 2022/ 7/ 29
destrians, stationary objects on
the road or road side, etc.
– Vehicles with body shapes that
the radar may not reflect (vehi-
cles with a low body height such
as sports cars or a trailer with no
cargo)
– Vehicles that are not approaching
your vehicle even though they
are in the detection area (either
on a neighboring lane to the rear
or beside your vehicle when
reversing) (The system deter-
mines the presence of approach-
ing vehicles based on data de-
tected by the radar sensors.)
– Vehicles traveling at significantly
different speeds
– Vehicles driving parallel to your
vehicle at almost the same speed
for a prolonged time
– Oncoming vehicles
– Vehicles in a lane beyond the
neighboring lane
– Vehicles travelling at a signifi-
cantly lower speed that you are
trying to overtake
. On a road with extremely narrow
lanes, the system may detect vehi-
cles driving in a lane next to the
neighboring lane.
& BSD/RCTA approach indica-
tor light/warning buzzer
S07BM03
When the BSD/RCTA is active, the BSD/
RCTA approach indicator light will operate
to alert the driver when there are vehicles
in the neighboring lanes. When reversing
the vehicle, the BSD/RCTA approach
indicator light and warning buzzer will
operate to alert the driver that a vehicle is
approaching from the left or right side.
! BSD/RCTA approach indicator light
S07BM0301
BSD/RCTA approach indicator light
It is mounted in each side of the outside
mirrors.
The indicator light will illuminate when a
vehicle approaching from behind is de-
tected.
The indicator light will flash to warn the
driver of dangers under the following
conditions.
. While the indicator light illuminates, if
you operate the turn signal lever toward
the side in which this light turned on.
. When reversing the vehicle while the
system detects a vehicle approaching
from either side.
! BSD/RCTA approach indicator
light dimming function
S07BM030101
When the headlights are turned on, the
brightness of the BSD/RCTA approach
indicator light will be reduced.
NOTE
. You may have difficulty recognizing
the BSD/RCTA approach indicator
light under the following conditions.
– When affected by direct sunlight
– When affected by the headlight
beams from the vehicles behind
. While the illumination brightness
control dial is in the fully upward
position, even if the headlights are
turned on, the brightness of the
BSD/RCTA approach indicator light
will not be reduced. For details about
the illumination brightness control
dial, refer to “Illumination bright-
ness control” �P171.
BSD/RCTA
386
To Next Page
Loading...
Need help?
General
