北米Model "A3240BE-A" EDITED: 2022/ 7/ 29
Hitch harness connector (4-pin type)
10. Connect the hitch wire harness’s black
4-pin or 7-pin wire connector to the
towing trailer’s wire harness.
11. Confirm proper function of the hitch
wire harness by individually activating
the brake, stop and turn signal lights on
the trailer.
NOTE
Always disconnect the trailer wire har-
ness before launching or retrieving a
watercraft.
& If not towing a trailer
S08AK02
. Remove the ball mount from the hitch
receiver tube and insert the receiver
cover onto the hitch receiver tube and/
or install bumper cover.
. Place the dust cap over the 4-pin or 7-
pin connector of the hitch wire harness
to protect against possible damage.
. Occasionally lubricate terminals of the
4-pin or 7-pin connector using terminal
grease.
8-12. Trailer towing
S08AL
Your vehicle is designed and intended to
be used primarily as a passenger-carrying
vehicle. Towing a trailer puts additional
loads on your vehicle’s engine, drivetrain,
brakes, tires and suspension and has an
adverse effect on fuel economy.
If you do decide to tow a trailer, your safety
and satisfaction depend upon proper use
of correct equipment and cautious opera-
tion of your vehicle.
Drive carefully when towing a trailer, and
always consider the following conditions.
. Road conditions
. Weather conditions
. Vehicle load weight
. Trailer load weight
Seek the advice of your SUBARU dealer to
assist you in purchasing a hitch and other
necessary towing equipment appropriate
for your vehicle. Do not use towing equip-
ment other than genuine SUBARU towing
equipment. In addition, be sure to follow
the instructions for proper installation and
use provided by the trailer or caravan’s
manufacturer.
SUBARU assumes no responsibility for
injuries or vehicle damage that result from
trailer towing equipment, or from any
Trailer towing
434
To Next Page
Loading...
Need help?
General
