28
5
Mechanical Mounting
Respect all local standards and requirements during mechanical installation.
5.1 Safety During Mounting
Make sure there is no electrical connection before installation.
Before drilling, avoid the water and electricity wiring in the wall.
Poor installation environment will affect system performance!
• Install the inverter in a well-ventilated place.
• Ensure that the heat dissipation system or vent is not blocked.
• Do not install the inverter in an environment with flammable and explosive ob-
jects or smoke.
Improper handling may cause personal injury!
• When moving the inverter, be aware of its weight and keep the balance to pre-
vent it from tilting or falling.
• Wear proper protective equipment before performing operations on the inverter.
• The bottom terminals and interfaces of the inverter cannot directly contact the
ground or other supports. The inverter cannot be directly placed on the ground.
When installing devices, ensure that no device in the system causes it hard for the
DC switch and the AC circuit breaker to act or hinders maintenance personnel from
operating.
If drilling is required during installation:
• Wear goggles and protective gloves when drilling holes.
• Make sure to avoid the water and electricity wiring in the wall before drilling.
• Protect the product from shavings and dust.
To Next Page
Loading...
Need help?
General
