Suzuki DL 650 2004 User Manual

Apply grease on the recessed portion of the joint plate holder
@ and set the joint plate @.
NOTE:
When positioning the joint plate @ on the tool, its stamp mark
must
face the joint plate holder @ side.
Set the drive chain on the tool as illustrated and turn in the
adjuster bolt
@ to secure the wedge holder & wedge pin @.
Turn in the pressure bolt "A @ and align two joint pins @
properly with the respective holes of the joint plate @
Turn in the pressure bolt "A @ further using the bar O to
press the joint plate over the joint pins.
Continue pressing the joint plate until the distance between
the two joint plates come to the specification.
Joint plate distance specification @
DID
18.70
- 18.90 mrn (0.736 - 0.744 in)
Should pressing of the joint plate be made excessively
beyond the specified dimension, the work should be
redone using the new joint parts.
JOINT PIN STAKING
Set up the special tool as shown in the illustration.
@ Tool body
@ Grip handle
@ Pressure bolt "A
@ Adjuster bolt (without hole)
a Staking pin (stowed inside grip handle behind rubber cap)
@ Bar
NOTE:
Before staking the joint pin, apply a small quantity of grease to
the staking pin
0.

Suzuki DL 650 2004 Specifications

General

Brand	Suzuki
Model	DL 650 2004
Category	Motorcycle
Language	English