CHASSIS 6-31
INSPECTION AND DISASSEMBLY
Inspect the removed parts for the following abnormalities.
* Handlebars distortion
* Race wear and brinelling
* Bearing wear or damage
* Abnormal noise of bearing
If any abnormal points are found, replace defective parts with the
new ones.
• Remove the steering stem lower bearing inner race with a chisel.
#
The removed bearing outer race must be replaced with a
new one.
• Drive out the steering stem bearing outer races, upper and
lower, using a suitable wedge bar.
#
The removed bearing outer race must be replaced with
a new one.
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering stem in the reverse order
of removal and disassembly.
Pay attention to the following points:
OUTER RACE
• Press in the upper and lower bearing outer races with the spe-
cial tools.
[[
[[
[ 09941-34513: Steering outer race installer set
INNER RACE
• Press in the lower bearing inner race with the special tool.
[[
[[
[ 09925-18011: Steering bearing installer
To Next Page
Loading...
Need help?
General
