3-44 ENGINE
OIL PUMP
INSPECTION
• Rotate the oil pump by hand and check that it moves smoothly.
• If it does not move smoothly, replace the oil pump assembly.
#
* Do not attempt to disassemble the oil pump assembly.
* The oil pump is available only as an assembly.
STARTER CLUTCH
INSPECTION
• Install the starter driven gear onto the starter clutch.
• Turn the starter driven gear by hand.
• Inspect the starter clutch for a smooth movement.
• Inspect that the gear turns one direction only.
• If a large resistance is felt for rotation, inspect the starter clutch
bearing or the starter clutch contacting surface on the starter
driven gear for wear and damage.
• If they are found to be damaged, replace them with new ones.
GENERATOR
INSPECTION:7-10
REASSEMBLY
• When installing the generator stator set bolts, tighten them to
the specified torque.
! Generator stator set bolt 1: 10 N
.
m (1.0 kgf
.
m, 7.0 lb-ft)
NOTE:
Be sure to install the grommet to the generator cover.
WATER PUMP
( 5-11)
To Next Page
Loading...
Need help?
General
