Sym PA12B User Manual

To this chapter contents
10. Brake System
10-13
Removal
Caution
z Brake linings must be replaced as a set.
Remove the brake shoes from the brake panel
by pulling out the brake shoes.
Installation
Apply a thin coat of grease to the brake cam
and the position pin.
Hook the brake shoe spring onto the brake
cam.
Pull out the brake shoes and install them onto
the brake panel.
Wipe off the excessive grease from the brake
cam installation.
Slightly grind the brake shoe surface with
sand-paper to clean the surface.
Caution
z Braking efficiency will be reduced if brake
shoe is contaminated by oil or grease.
Brake cam
Brake Panel
Removal
Remove the brake arm bolt, brake arm, brake
return spring and brake cam as well as the oil
seal from the brake panel.
Installation
Apply a thin cost of grease between the oil
seals on the brake cam.
Install the brake cam.
Align the mark on the brake arm with the inner
gear of the brake cam.
Tighten the bolts and nuts to specified torque.
Torque value：0.8~1.2kgf-m
Brake shoe
Position pin
Brake shoe spring
Bolt
Brake arm
Brake cam

Sym PA12B Specifications

General

Brand	Sym
Model	PA12B
Category	Motorcycle
Language	English