Takeuchi TB260 User Manual

2-55
CONTROLS
AUTOMATIC DECELERATION SWITCH
When the ON side of the switch is pressed,
the deceleration lamp in the instrument
cluster flashes. This flashing stops when the
deceleration function starts working, and the
lamp remains lit while in the deceleration
mode. The engine speed automatically drops
to low idle (deceleration mode) four seconds
after the control levers are set to neutral, to
reduce fuel consumption. Moving the control
levers will cause the speed to return to the
original engine speed.
Switching from the deceleration button to the
auto-deceleration switch will first return to
the engine speed set with the throttle
controller. Then, the engine will automatically
enter the deceleration mode (low idling) if the
control levers are not operated within four
seconds.
SWITCHES
POWER/HIGHLAND MODE SWITCH
• Power mode
· Pressing the PWR symbol side of the
switch turns on the Power mode
indicator lamp on the instrument cluster.
The maximum engine output is obtained.
· STD mode: Pressing the PWR symbol
side of the switch again turns off the
power mode indicator lamp.
• Highland mode
This switch is used to reduce the engine
load due to the hydraulic pump. When the
machine is operated at a high-altitude site,
the engine output is decreased due to thin
air. In such cases, the hydraulic horse
power is automatically adjusted to prevent
the engine from stalling. Use this switch
when the machine is operated at a high-
altitude site.
· Pressing the PWR symbol side of the
switch turns on the Power mode
indicator lamp on the instrument cluster.
· To cancel the highland mode, press the
PWR symbol side halfway to set to the
neutral position. The highland mode
indicator lamp goes out and enters the
lowland mode.
Refer to “Multi-information display” on
page 2-16.
Refer to “Instrument cluster” on page
2-28.

Takeuchi TB260 Specifications

General

Brand	Takeuchi
Model	TB260
Category	Excavators
Language	English