2-21
CONTROLS
MULTI-INFORMATION DISPLAY
SCREEN CONTROL KEY
Note: Do not press the symbol keys on the
display. The LCD could be damaged if the
symbol keys are pressed hard. For actual
operation, press the push button keys
located at the bottom of the screen.
A. Menu key
Use this key to switch between the Home
screen and the Menu screen. This key is
also used to cancel changes made in
each setting. The screen returns to the
Home screen if this key is pressed in the
information screen.
B. Hour meter key
This hour meter symbol is displayed in the
initial screen. Pressing this key changes
the meter display in the following order.
Trip meter 1, Trip meter 2, Trip meter 3,
Hour meter.
Down (
) key
Use this key to move the cursor
downward and to decrease the value in
each setting. Press and hold this key for
one second to rapidly decrease the value.
C. Bar meter key
This hour meter symbol is displayed in the
initial screen. Pressing this key changes
the meter display in the following order.
Throttle opening position, Lift load factor,
PM accumulation amount
Up (
) key
Use this key to move the cursor
upward
and to increase the value in each setting.
Press and hold this key for one second to
rapidly increase the value.
D. Auxiliary 1st key
The auxiliary 1st symbol is displayed in the
initial screen. Pressing this key changes
the symbol display in the following order.
Auxiliary 1st setting 1, Auxiliary 1st setting
2, Auxiliary 1st setting 3.
Enter key
Use this key to confirm or execute the
setting made by each key.
To clear the trip meter being displayed,
press and hold this key for three seconds.
E. Camera image key (If equipped)
<Applicable machine models 126001208 or
later>
Do not look at the images produced by
the camera when traveling in reverse.
Move in reverse while visually looking at
the direction of travel.
1. Press the Camera key in the Main screen
to display the images taken by the rear
camera.
2. Press the Camera key again or other key
to return to the Main screen.
To Next Page
Loading...
Need help?
General
