5-24
MAINTENANCE
AFTER THE INITIAL 50
HOURS (ONLY FOR NEW
MACHINES)
REPLACING THE ENGINE OIL AND THE
OIL FILTER
Stop the engine and allow the machine to
cool down before performing
maintenance.
• The engine, muffler, radiator, hydraulic
lines, sliding parts and many other parts
of the machine are hot immediately after
the engine is stopped. Touching these
parts will cause burns.
• The engine oil is also hot.
Be careful not to touch the hydraulic oil
when loosening the cap or plug.
Working on the machine under these
conditions could result in burns or
injuries.
Engine oil
AFTER THE INITIAL 50 HOURS (ONLY FOR NEW MACHINES)
1. Open the engine hood and remove the oil
filler cap (2).
2. Loosen the bolts and remove the under
cover (3).
3. Place a pan for catching the waste oil
under the drain plug (4).
4. Remove the cap (A), install connector (B)
and drain the oil. (The oil comes out when
the screw is tightened.)
5. Remove the connector (B) and install the
cap (A).
6. Install the under cover (3).
IMPORTANT: Check the waste oil for
metal powder. If it contains large amounts
of metal powder, consult your sales or
service dealer.
To Next Page
Loading...
Need help?
General
