5-62
MAINTENANCE
LUBRICATING THE LEVERS AND PEDALS
Set the machine to the parking posture,
stop the engine, remove the starter key
and store it. Failure to do so may result in
the machine moving abruptly, leading to
serious injury or death.
If the levers or pedals no longer move
smoothly, grease them.
Operating levers
WHEN REQUIRED
Travel levers
Boom swing pedal
Dozer blade lever
1. Remove the lower mount section of the
boot (1) and turn it upward.
2. Wipe off the old grease.
3. Apply grease to points (A) and (B).
4. Set the boot (1) back as it was.
4. Close the drain valve (7) and tighten the
plug (8).
Refer to “Bleeding air from the fuel
system” on page 6-8.
To Next Page
Loading...
Need help?
General
