CBR CGA4131COM- User Guide
17 of 61
2 Setup
Setup procedure
Complete the following steps to setup the Gateway:
1. Connect your Gateway to your service provider’s network.
For more information, see “2.1 Connect the Gateway to your service provider’s network”.
2. Power on the Gateway.
For more information, see “2.2 Power on the Gateway”.
3. Connect your wired devices to the Gateway.
For more information, see “2.3 Connect your wired devices”.
4. Connect your wireless devices to the Gateway.
For more information, see “2.4 Connect your wireless devices”.
5. Connect your phones.
For more information, see “2.5 How to connect your phone”.
Optional configuration
After completing the setup procedure, the Gateway is ready for use. Optionally, you can further configure
the Gateway to your needs (for example, change the wireless security) using the Gateway’s Admin Tool.
For more information, see “3 Admin Tool”.
2.1 Connect the Gateway to your service provider’s network
Introduction
This section helps you connect the Gateway to your service provider’s network.
Connecting the cables
Proceed as follows:
1. Take one end of the coaxial cable and connect it to your cable splitter.
2. Connect the other end to the Cable port of the Gateway.
To Next Page
Loading...
Need help?
General
