CBR CGA4131COM- User Guide
27 of 61
The Gateway’s Network Name (SSID) is printed on the Gateway's side or back panel label. For more
information, see “Product label (item B)”.
3. The WiFi window prompts you to enter your WPA password.
In the Password box, type the Password (Key) which is printed on the Gateway's bottom panel label and
select the Remember this network box and click OK.
4. You are now connected to the Gateway network.
2.5 How to connect your phone
Introduction
This section describes how to connect the phones for single line customers.
If you have a two-line setup or a setup involving an alarm, please contact your service provider. This setup must
be done by qualified technicians
.
Procedure
Connect your traditional phone, external DECT base station or fax to an active RJ-11 Telephone jack on the back
panel of your Gateway.
1. Plug the other end of the telephone cable into the telephone device.
2. You must use connect Alarms dialers to either port 1 or 2. You are responsible to ensure that Alarms
dialer is connected to an active telephone port connected to the phone network.
3. You must verify that each phone line is active by first checking for dial tone, and then by placing a call
to an active telephone number and checking that both parties can properly hear one another.
To Next Page
Loading...
Need help?
General
