User’s Manual 4-19
Operating Basics
DLA for TOSHIBA
Note the following limitations when you use DLA:
■ This software supports only rewritable discs (DVD+RW, DVD-RW, and
CD-RW). It does not support DVD+R, DVD-R, and CD-R discs that are
not rewritable.
■ DLA does not support formatting a DVD-RAM disc and writing to it, this
function is performed by DVD-RAM Driver Software. You may find that
the DLA Format menu appears when inserting a DVD-RAM disc,
although you should use the 'DVDForm' utility to format this disc. You
can run 'DVDForm' by clicking the Start button and then selecting 'All
Programs', 'DVD-RAM', 'DVD-RAM Driver' and 'DVDForm' sequentially.
■ Do not use any discs that have been formatted with packet writing
software other than DLA. Similarly, do not use any discs that have been
formatted with DLA with any packet writing software other than DLA.
When using a disc you are not familiar with, format it by selecting “Full
Format” before using it.
■ Do not use the cut-and-paste function for files and folders. A file or
folder that has been cut may be lost if writing fails due to an error on the
disc.
■ When writing SETUP files for an application to a disc formatted by DLA,
and then attempting to start SETUP from this disc, an error may occur.
In this case, please copy the SETUP files to the hard disk and then run
them from there.
Video
As for InterVideo WinDVD Creator Platinum. Only the model that can be
written in to DVD is attached.
When using WinDVD Creator Platinum
You can record video back to your digital camcorder via i.LINK (IEEE1394)
using WinDVD Creator Platinum. However, there is a case where you may
find that playback sound is choppy -if this is the case follow the below
instructions:
1. Click start and select the Control Panel.
2. Click the Performance and Maintenance icon in the Control Panel.
3. Click the System icon in the Performance and Maintenance window.
4. Click the Advanced tab in the System Properties window.
5. Click the Settings icon in the "Performance" section.
6. Click the Advanced tab in the Performance Options window.
7. Click the Change icon in the "virtual memory" section.
8. Select the Custom size button in the Virtual Memory window.
9. Specify much higher values for "Initial size" and "Maximum size."
10. Click the Set button in the Virtual Memory window.
11. Click the OK button in the Virtual Memory window.
To Next Page
Loading...
Need help?
General