10-18 User’s Manual
Troubleshooting
i.LINK (IEEE1394) device
Video Playback
Disposing of PC and PC batteries
■ Discard this PC in accordance with ordinances or rules of local
regulations. For further information, contact your local government.
■ This PC contains rechargeable batteries. After repeated use, the
batteries will finally lose their ability to hold a charge and you will need
to replace them. Under certain applicable laws and regulation, it may be
illegal to dispose of old batteries by placing them in the trash.
Problem Procedure
i.LINK device does not
function
Make sure the cable is securely connected to the
computer and to the device.
Make sure the device’s power is turned on.
Click start, click Control Panel and double-click
the Add Hardware icon. Follow the on-screen
directions.
Restart Windows.
If problems persist, contact your dealer.
Problem Procedure
DVD does not play
smoothly when using
the Windows Media
Center Edition of the
DVD playing software
Try setting the configuration in the BIOS setup.
However, note that when the BIOS setup
configuration is modified, the power saving
function of PCI Express becomes disabled. Refer
to Chapter 7, HW Setup for more information.
Set the PCI Express Link ASPM in the BIOS
setup using the following steps:
1. Press the F1 key. The BIOS setup screen will
appear.
2. Set the PCI Express Link ASPM to "Disabled"
in BATTERY.
3. Press the End key. A confirmation message
will appear.
4. Press the Y key. The BIOS setup will
terminate and the computer will reboot.
If problems persist, contact your dealer.
To Next Page
Loading...
Need help?
General