User’s Manual 3-9
Getting Started
Opening the display
The display panel can be rotated in a wide range of angles for optimal
viewing.
1. Push the display latch on the front of the computer to unlatch the
display panel.
2. While holding down the palm rest with one hand so that the main body
is not raised, lift the panel slowly. Adjust the angle of the panel to
provide optimal clarity.
Figure 3-5 Opening the display
Turning on the power
This section describes how to turn on the power.
1. Open the computer’s LCD display panel.
As the display panel cannot be opened until 180 degrees, please be
careful of the angle when flipping open the display panel.
Use reasonable care when opening and closing the display panel.
Opening it vigorously or slamming it shut could damage the computer.
Display latch
■ After you turn on the power for the first time, do not turn it off until you
have set up the operating system. Refer to the section Starting up for
the first time.
■ If the USB floppy disk drive is connected, make sure it is empty. If a
floppy disk is in the drive, press the eject button and remove the floppy
disk.
To Next Page
Loading...
Need help?
General