3-52 OM 25-3503 us – Edition 4.1 * * 2503_3503b330.fm
Operation
3.31 Seat belt
Injury hazard due to unfastened seat belt!
Can cause serious injury or death.
• Buckle up before starting machine travel or operation!
• Seat belt must not be twisted!
• Seat belt must run over the hips – not over the stomach – and must
always be applied tightly!
• Do not place the seat belt over hard, edged or fragile items (tools, rulers,
glasses, pen) carried inside your clothes!
• Never buckle up 2 persons (children!) with one seat belt!
• Check seat belts regularly. Have damaged parts immediately replaced
by a Wacker Neuson service center!
• Always keep the seat belt clean, as coarse dirt can impair proper func-
tioning!
• Seat belt buckle must not be obstructed by foreign bodies (paper or sim-
ilar); otherwise the buckle latch cannot lock into place!
After an accident the belt strap is stretched and no longer serviceable.
In an accident, the seat belt
Will not provide appropriate protection!
• Replace the seat belt after an accident
• Have fastening points and seat fixture checked for bearing capacity!
Seat belt 11 is for the operator’s safety during work on construction sites and during road
travel.
Fastening the seat belt:
☞ Fasten seat belt 11 as follows before starting machine travel:
•Hold belt on buckle latch A and run it slowly and steadily over the hips to
buckle B
•Insert buckle latch A into buckle B with an audible click (pull test)
•Tighten the seat belt by pulling at its end
➥The seat belt must always be tightly in place over the hips!
Fig. 136: Fastening the seat belt
B
A
11
To Next Page
Loading...
Need help?
General
