OM 803 us – Edition 3.7 * 803b210us.fm 2-17
Safety instructions
Gas, dust, steam, smoke
• Operate the machine only on adequately ventilated premises. Before starting internal
combustion engines or operating fuel-operated heating systems on enclosed premises,
ensure that there is sufficient ventilation. Observe the regulations in force at the
respective site.
• Welding, burning and grinding work on the machine may only be performed by a
Wacker Neuson dealer.
• Before performing welding, flame-cutting and grinding work, clean the machine and its
surroundings from dust and other inflammable substances, and ensure that the
premises are adequately ventilated – explosion hazard.
• In areas with special hazards (for example, toxic gases, caustic vapors, toxic environ-
ments), carry appropriate protective equipment (breathing filters, protective clothing).
• Do not use the vehicle in radioactively, biologically or chemically contaminated areas.
Hydraulics
• Work on the hydraulic equipment of the machine must be performed only by persons
having specific technical knowledge and experience in hydraulic systems.
• Check all lines, hydraulic hoses, fittings, and threaded couplers regularly for leaks and
obvious damage. Repair any damage and leaks immediately. Splashed oil can cause
injury and fire.
• In accordance with the Operator's Manual for the respective assembly, release the
pressure in all system sections and pressure lines (hydraulic system) to be opened
before performing any implementing/repair work.
• Hydraulic and compressed-air lines must be laid and fitted properly. Ensure that no
connections are interchanged. The fittings, lengths and quality of the hydraulic hoses
must comply with the technical requirements.
Noise
• Close all doors and windows if practical.
• Removing sound baffles on the machine during operation is prohibited.
• Wear ear protectors. This is especially important when performing hammer operations
or working in enclosed areas.
MSDS
• When handling oil, grease and other chemical substances such as battery electrolyte or
hydraulic fluid, observe the product-related safety regulations (Material Safety Data
Sheet (MSDS)).
• Be careful when handling hot consumables – burn hazard.
• When using the machine in contaminated areas, take appropriate measures for the
protection of the operator and the machine.
Tracks
• Check track tension at regular intervals.
• Repair work on the tracks must be performed by technical personnel or by Wacker
Neuson dealers only.
• Damaged or malfunctioning tracks reduce the machine’s operational safety. Check the
tracks regularly for:
• Cracks, cuts or other damage.
To Next Page
Loading...
Need help?
General
