Service Settings
ColorQube 9301/9302/9303 Multifunction Printer
User Guide
209
Embedded Fax Settings
Select the Embedded Fax Settings option to access the following settings:
• Fax Setup on page 209
• Feature Defaults on page 207
• Fax Country Setting on page 209
• Line 1 Setup on page 209
• Line 2 Setup on page 210
• Incoming Fax Defaults on page 210
• Transmission Defaults on page 211
• Mailbox and Polling Policies on page 212
• Mailbox Setup on page 212
• Setup Fax Reports on page 213
• Print Fax Reports on page 213
Fax Setup
Use this setting to Enable or Disable Embedded Fax.
• Enable activates the Embedded Fax service and is selectable from the Services Home screen.
• Disable switches off the service, and it is not available for selection.
Feature Defaults
Use this setting to select the default settings for each programing feature within the Embedded Fax
service.
1. Select the default required for each feature in each of the programing tabs.
2. Select Save Defaults. The settings selected become the default settings for each fax job.
3. A confirmation screen is displayed.
Select Done to return to the previous screen.
Fax Country Setting
Use this option to select the country the printer is located in. Select the Country required from the
options shown.
Line 1 Setup
The standard fax option supports one analog telephone line. If the Extended Fax option is installed, the
printer can support two analog telephone lines. This option enables you to set up Line 1.
• Fax Number is the number of phone lines the system is attached to. Type the number for Line 1,
using the numeric keypad.
To Next Page
Loading...
Need help?
General
