70 4 Setting on the Control Panel
Parallel Settings
Specifies the settings for the parallel interface.
Note
• You need to restart the printer to activate the new settings. After making the settings, turn off the printer
and then turn it on again.
Adobe Protocol Sets the PostScript communication protocol.
• [Auto] (default)
Automatically detects the PostScript communication protocol.
• [Standard]
Select this when the communication protocol is in ASCII format.
• [BCP]
Select this when the communication protocol is in binary format.
• [TBCP] Select this when the communication protocol are both in ASCII and binary
formats and switches between the two using control codes.
• [Binary]
Select this when no special processing is required for data.
Note
• The DocuPrint C2100 does not support [Adobe Protocol].
• Select an appropriate option according to the data format specified on your printer
driver.
• [Adobe Protocol] is valid only when printing in PostScript.
Item Description
Bi-directional Specifies the Bi-directional communication mode of the parallel interface.
• [Enable] (default)
The Bi-directional communication mode is enabled.
• [Disable]
The Bi-directional communication mode is disabled.
Adobe Protocol Sets the PostScript communication protocol.
• [TBCP](default)
Select this when the communication protocol are both in ASCII and binary formats
and switches between the two using control codes.
• [Binary]
Select this when no special processing is required for data.
• [Auto]
Automatically detects the PostScript communication protocol.
• [Standard]
Select this when the communication protocol is in ASCII format.
• [BCP]
Select this when the communication protocol is in binary format.
Note
• The DocuPrint C2100 does not support [Adobe Protocol].
• Select an appropriate option according to the data format specified on your printer
driver.
• [Adobe Protocol] is valid only when printing in PostScript.
Item Description
To Next Page
Loading...
Need help?
General