Xerox Phaser 6280 Service Manual

Phaser 6280 Color Laser Printer Service Manual 3-45
Error Messages and Codes
Jam at Tray 2 (Feed Jam)
Paper fed from Tray 2 did not reach the Registration Sensor on time.
Applicable Chain Link
■ Chain Link 077-903: Jam at Tray 2
Initial Actions
■ Ensure that Tray 1 (MPT) is attached to the printer.
■ Try picking paper from a different tray.
■ Check the paper path for obstructions or debris.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■ Tray 1 (MPT) Retard Roller Assy.,
PL2.1.3
■ Roll Assy Feed (Feed Roll), PL3.1.10
■ Feeder Assy., PL3.2.1
■ Regi Sensor, PL3.2.30
■ Regi Sensor Harness, PL3.2.37
■ Feed Roll, PL3.2.53
■ MCU Board, PL9.1.20
■ Right Side Harness, PL10.1.15
■ “Map 2 - Laser Unit, Feeder Assembly”
on page 10-10
■ “Map 4 - LVPS and MCU Boards” on
page 10-12
■ “Tray 1 (MPT) and Registration” on
page 10-23
■ “Feeder” on page 10-27
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check for paper jam.
2.Remove the jammed paper.
3.Does the error still occur?
Go to step 2. Complete.
2 1.Perform the Registration Sensor
test (page 4-30): Service Mode >
Engine Diag > Sensor Test > Regi
Sensor.
2.Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
Go to step 8. Go to step 3.

Xerox Phaser 6280 Specifications

General

Brand	Xerox
Model	Phaser 6280
Category	Printer
Language	English