Xerox Phaser 6280 Service Manual

Phaser 6280 Color Laser Printer Service Manual 3-51
Error Messages and Codes
Consumable/Routine Maintenance Procedures
Insert Fuser
The printer does not detect the presence of the Fuser.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
■ Chain Link 010-317: IOT Fuser Detached
Initial Actions
■ Ensure that the Fuser latches are fully locked.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■ Fuser, PL6.1.10
■ Fuser Harness, PL6.1.11
■ MCU Board, PL9.1.20
■ “Map 1 - Electrical and Drive” on
page 10-9
■ “Map 4 - LVPS and MCU Boards” on
page 10-12
■ “Fuser” on page 10-35
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the Fuser for correct installation.
2.Is the Fuser correctly installed?
Go to step 3. Reseat the
Fuser
(
page 8-11).
Go to step 2.
2 Does the error still occur? Go to step 3. Complete.
3 1. Check the wiring harness connectors P/
J17 and P/J171 between the MCU Board
and the Fuser.*
2.Are the connectors securely connected?
Go to step 4. Reconnect
the
connectors.
Go to step 4.

Xerox Phaser 6280 Specifications

General

Brand	Xerox
Model	Phaser 6280
Category	Printer
Language	English