Xerox Phaser 6280 Service Manual

Phaser 6280 Color Laser Printer Service Manual 3-125
Error Messages and Codes
4 1. Perform the Tray 2 Motor test
(page 4-43): Service Mode >
Engine Diag > Motor Test > Tray 2
Motor. During the test, close the
Front Cover.
2.Does the Motor operate properly?
Replace the
MCU Board
(
page 8-86).
Go to step 5.
5 1. Check the PH Drive Assembly for
correct installation.
2.Is the PH Drive Assembly correctly
installed?
Go to step 6. Reseat the PH
Drive Assembly
(
page 8-73).
Go to step 6.
6 Does the error still occur? Go to step 7. Complete.
7 Check the Right Side Harness for
continuity.
1.Disconnect P/J25 from the MCU
Board and P/J251 from the PH Drive
Assembly.
2.Check continuity between P/J25 <=>
P/J251.
Go to step 8. Replace the
Right Side
Harness.
8 Check the PH Drive Assembly signal.
1.Disconnect P/J25 from the MCU
Board.
2.Are there +24 V across ground <=>
J25-1/J25-2 pin when the Interlock
Switch is activated?
Replace the PH
Drive Assembly
(
page 8-73).
Replace the
MCU Board
(
page 8-86).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No

Xerox Phaser 6280 Specifications

General

Brand	Xerox
Model	Phaser 6280
Category	Printer
Language	English