Xerox Phaser 6280 Service Manual

Phaser 6280 Color Laser Printer Service Manual 8-33
Service Parts Disassembly
5. Remove the E-ring securing the bearing on the left and right sides of the
Roll, and shift the bearing toward the inside.
Note
When performing the following step, be careful not to loose the Earth
Bearing (PL3.1.6) and the Bearing (PL3.1.13).
6. Shift the Roll to the right and pull out the left side shaft section of the Roll
from the bearing. Pull the Tray 1 (MPT) Roll out toward the lower left side
to remove it.
Replacement Note
Replacement Note
Pay attention to the orientation of the Bearings. The right side of the
Bearing (PL3.1.6) is Black; the left side of the Bearing (PL3.1.13) is
White.
Ensure the D cut surface of the Shaft faces upward which makes the
installation process easier.
Attach the elliptical side of the mounting section of the MPT Feed
Spring to the Gear.
s6280-192
Black
White

Xerox Phaser 6280 Specifications

General

Brand	Xerox
Model	Phaser 6280
Category	Printer
Language	English