• Do not plug or unplug the power cord while the power switch is in the On position.
• To avoid electrical shock and damage to the cord, grasp the plug when unplugging the power
cord.
• Ensure that the electrical outlet is near the printer and is easily accessible.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is
necessary to disconnect all electrical power from the printer, disconnect the power cord from the
electrical outlet.
EEmmeerrggeennccyy PPoowweerr OOffff
If any of the following conditions occur, power the printer off immediately. Disconnect the power cord
from the electrical outlet. Contact an authorized Xerox service representative to correct the problem if
any of the following occurs:
• The equipment emits unusual odors or makes unusual noises.
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device has been tripped.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• Any part of the printer is damaged.
LLaasseerr SSaaffeettyy
This printer complies with laser product performance standards set by governmental, national, and
international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous
light because the beam is enclosed completely during all modes of customer operation and
maintenance.
Laser Warning: Use of controls, adjustments, or performance of procedures other than those
specified in this manual can result in hazardous radiation exposure.
12
Xerox
®
WorkCentre
®
3335/3345 Multifunction Printer
User Guide
Safety
To Next Page
Loading...
Need help?
General
