PPrriinnttiinngg TTaakkeess TToooo LLoonngg
Probable Causes Solutions
The printer is set to a slower printing mode. For
example, the printer could be set to print on
Heavyweight paper.
It takes more time to print on certain types of special
paper. Ensure that the paper type is set properly in
the driver and at the printer control panel. For details,
refer to Print Speed.
The printer is in Power Saver mode. It takes time for printing to start when the printer is
exiting Power Saver mode.
The way the printer was installed on the network
could be an issue.
Determine if a print spooler or a computer sharing
the printer is buffering all print jobs and then
spooling them to the printer. Spooling can slow print
speeds. To test the speed of the printer, print some
information pages such as the Office Demo Page. If
the page prints at the rated speed of the printer, you
could have a network or printer installation issue. For
help, contact the system administrator.
The job is complex. Wait. No action is needed.
The print-quality mode in the driver is set to
Enhanced.
Change the print-quality mode in the print driver to
Standard.
PPrriinntteerr FFaaiillss ttoo PPrriinntt
Probable Causes Solutions
The printer has an error.
• To clear the error, turn off the printer, then turn it
on again.
• If the error persists, contact your Xerox
representative.
The printer is out of paper. Load paper into the tray.
A toner cartridge is empty. Replace the empty toner cartridge.
The power cord is not correctly plugged into the
outlet.
Turn off the printer, confirm that the power cord is
plugged in correctly to the printer and the outlet,
then switch on the printer. For details, refer to
Powering On or Off the Printer. If the error persists,
contact your Xerox representative.
148
Xerox
®
WorkCentre
®
3335/3345 Multifunction Printer
User Guide
Troubleshooting
To Next Page
Loading...
Need help?
General
