Xerox WorkCentre 6515 User Manual

System Administrator Functions
Configuring Power Saver Using the Embedded Web Server
You can set the time that the printer spends idle in ready mode before it automatically transitions to a
lower power level.
To configure Power Saver Timeouts:
1. At your computer, open a Web browser. In the address field, type the IP address of the printer, then
press Enter or Return.
2. In the Embedded Web Server, click System > Power Saver.
Note: If this feature does not appear, log in as a system administrator. For details, refer to Logging
In as the Administrator on page 265.
3. To set the time delay before the printer enters Low-Power mode, for Low Power Timeout, click
current value, then type the desired timeout in minutes.
4. To set the time delay before the printer enters Sleep mode, for Sleep Timeout, click current value,
then type the desired timeout in minutes.
Note: The sum of the two timeouts is within 60 minutes.
5. To set Auto Power Off, click Auto Power Off:
− To power off the device after all timeouts complete, select On, click current value, then type the
desired timeout in hours.
− To power off the device only if specific conditions are met:
• Select Only When Conditions Are Met.
• Click current value, then type the desired timeout in hours.
Specific conditions are when Fax, USB Drive, Wired and Non-Wired Network features have not
been activated.
6. To finalize your selections, click OK.
Xerox
®
WorkCentre
®
6515 Color Multifunction Printer 235
User Guide

Xerox WorkCentre 6515 Specifications

General

Brand	Xerox
Model	WorkCentre 6515
Category	All in One Printer
Language	English