Xilinx ChipScope Pro User Manual

30 www.xilinx.com ChipScope Pro Software and Cores User Guide
UG029 (v14.3) October 16, 2012
Chapter 1: Introduction
Board Requirements
For the ChipScope Pro Analyzer tool and download cable to work properly with the
board-under-test, the following board-level requirements must be met:
• One or more supported devices must be connected to a JTAG header that contains the
TDI, TMS, TCK, and TDO pins
• If another device would normally drive the TDI, TMS, or TDI pins of the JTAG chain
containing the target device(s), then jumpers on these signals are required to disable
these sources, preventing contention with the download cable
• If using the Parallel Cable IV, Platform Cable USB, Digilent JTAG-HS1, or ByteTools
download cable, then VREF (1.5-5.0V) and GND headers must be available for
connecting to the Parallel Cable IV cable
Software Installation and Licensing
The ChipScope Pro Analyzer tool can be installed both as a standalone ISE Lab Tools
product (for example, in a lab environment where only the ChipScope Pro Analyzer tool is
needed) or along with the rest of the ISE Design Suite tools. For software installation and
licensing instructions, refer to the ISE Design Suite Installation and Licensing Guide,
available in the ISE Documentation
[See Reference 14, p. 225].

Xilinx ChipScope Pro Specifications

General

Brand	Xilinx
Model	ChipScope Pro
Category	Computer Hardware
Language	English