Xilinx VC707 User Manual

58 www.xilinx.com VC707 Evaluation Board
UG885 (v1.4) May 12, 2014
Chapter 1: VC707 Evaluation Board Features
VITA 57.1 FMC1 HPC Connector (Partially Populated)
[Figure 1-2, callout 30]
The VC707 board implements two instances of the FMC HPC VITA 57.1 specification
connector. This section discusses the FMC1 HPC J35 connector.
Note:
The FMC1 HPC J35 connector is a keyed connector oriented so that a plug-on card faces
away from the VC707 board.
The VITA 57.1 FMC standard calls for two connector densities: a high pin count (HPC) and
a low pin count (LPC) implementation. A 400 pin 10 x 40 position connector form factor is
used for both versions. The HPC version is fully populated with all 400 pins present. The
LPC version is partially populated with 160 pins.
The 10 x 40 rows of an FMC HPC connector provides pins for up to:
• 160 single-ended or 80 differential user-defined signals
• 10 GTX transceivers
•2 GTX clocks
•4 differential clocks
• 159 ground and 15 power connections
The VC707 board FMC1 HPC connector J35 implements a subset of the maximum signal
and clock connectivity capabilities:
• 80 differential user-defined pairs
• 34 LA pairs (LA00-LA33)
• 24 HA pairs (HA00-HA23)
• 22 HB pairs (HB00-HB21)
•8 GTX transceivers
•2 GTX clocks
•2 differential clocks
The FMC1 HPC signals are distributed across GTX Quads 118 and 119. Each Quad has the
VCCO voltage connected to VADJ.
Note:
The VC707 board VADJ voltage for the FMC1 HPC (J35) connector is determined by the
FMC VADJ power sequencing logic described in FMC_VADJ Voltage Control, page 72.
VITA 57.1 FMC2 HPC Connector (Partially Populated)
[Figure 1-2, callout 31]
The VC707 board implements two instances of the FMC HPC VITA 57.1 specification
connector. This section discusses the FMC2 HPC J37 connector.
Note:
The FMC2 HPC J37 connector is a keyed connector oriented so that a plug-on card faces
away from the VC707 board.
The FMC standard calls for two connector densities: a High Pin Count (HPC) and a Low
Pin Count (LPC) implementation. A 400 pin 10 x 40 position connector form factor is used
for both versions. The HPC version is fully populated with all 400 pins present. The LPC
version is partially populated with 160 pins.
Send Feedback

Xilinx VC707 Specifications

General

Brand	Xilinx
Model	VC707
Category	Motherboard
Language	English