The rigidity level should be set according to the actual load. The larger the P-04 value, the greater the
servo gain. If there is vibration in the process of increasing the rigidity level, it is not suitable to
continue to increase. If vibration suppression is used to eliminate vibration, it can try to continue to
increase. The following is the recommended rigidity level of the load, for reference only.
Flexible structure large load: refers to the type of synchronous belt structure, large load inertia
equipment.
High rigid load: refers to the mechanism of screw rod or direct connection, and equipment with strong
mechanical rigidity.
Ultra-high response load under light load: refers to equipment with very small inertia, strong
To Next Page
Loading...
Need help?
General
