| How to Manage Calls | 47
Add Additional Headset(s) without Docking
Procedure
1. Power off the additional headset by pressing the Call Control button for 3 seconds without docking
until you hear "power off".
2. Put the additional headset into pairing mode by pressing the Call Control button for 5 seconds until
you hear "power on, pairing mode", and the button flashes orange.
3. Put the base into pairing mode.
• For WH62/WH63 in idle state, press the PC button for 5 seconds until the button flashes green and
white.
•
For WH66/WH67 during a call, go to > Add Headset > Pair without docking.
A tone indication will play in the primary headset.
4. Press the Call Control button on the primary headset within 10s to accept the additional headset.
Results
When the additional headset is added successfully, you will hear "new headset joined" in the primary
headset.
End or Leave a Conference Call
• To end the conference for all headsets:
1. Press the Call Control button on the primary headset, or dock the primary headset in the base.
• To leave the conference:
1. Press the Call Control button on the additional headset, the conference call will continue for all other
headsets.
Transfer a Call from Desk Phone to Headset
Before you begin
• The base is connected to the Yealink phone via USB.
• A call is answered on the phone using the handset or speakerphone.
Procedure
1. For WH62/WH63, do one of the following:
• Press the Call Control button on the headset.
• Lift the headset from the base.
If necessary, press the HEADSET key on the desk phone. The audio will transfer from the desk phone
to the headset.
2. For WH66/WH67, press the HEADSET key on the desk phone.
The audio will transfer from the desk phone to the headset.
Transfer a Call from Headset to Desk Phone
To Next Page
Loading...
Need help?
General
