| Pair the Headset with Base | 9
Power off the Base
Procedure
1. For WH62/WH66/WH67 base, unplug the power adapter.
2. For WH63 base, unplug the power adapter and disconnect from the USB device.
Power off the Headset
Procedure
Undock the headset and hold the Call Control button for 3 seconds.
You hear a "power off" tone indicating headset status.
Note: Power off the headset will only disconnect the connection between the base and the
headset, but will not delete the pairing information between the base and the headset.
Pair the Headset with Base
Before you begin
The base has been connected to a power supply.
Procedure
Dock the headset in a base.
Results
The headset is successfully paired with the base. The LED on the headset glows green for 5 seconds, and
then indicates the charging status.
Note: After the primary headset is paired, the primary headset will keep paired even you undock
it. You can pair up to three additional headsets to the base for conferencing. After the conference
ends, all additional headsets will disconnect from the base automatically.
Related tasks
Add Additional Headset(s) During a Call
Add Additional Headset(s) When the Base is Idle
Unpair the Headset with Base
Before you begin
The headset has paired with the base.
To Next Page
Loading...
Need help?
General
