File Errors
Code Message Chapter or
Section
501 Invalid file name.
The name contains prohibited characters, or file name is duplicated.
6.3
1
502 Pass name over maximum number of characters.
Full pass name should under 255 characters.
6.3
1
504 Out of disk space. –
505 File not found.
Check the file.
–
506 Duplicate file or directory name.
Change the name.
–
507 The file name is not set.
Set the file name.
6.3
1
508 Save data not found.
Check for presence of data and channel.
Chapter 6
1
510 Cannot load this file format.
Files stored on other models cannot be loaded.
–
511 File is now being accessed.
Execute after access is made.
–
513 The specified file cannot be loaded on this Firmware version or this model. –
514 No ch is displayed.
Turn ON the display of the appropriate channel.
Chapter 2
1
516 SD Card recording error.
The operation is aborted.
–
517 Unknown file format. Chapter 6
1
519 Cannot save in this format at the current record length.
Specify a range and save a section of the data.
* Cannot create a file of size 2 GB or larger.
–
520 Media error. –
521 Directory can not be deleted. 6.1
1
522 Cannot load these files on a network drive.
The File which larger than 50 Mbyte.
Copy the file to the local drive before loading it.
Chapter 19
1
533 Writing prohibited in this file. –
534 An error occurred while network access.
Confirm network conditions.
Chapter 19
1
535 Current path is not suitable.
Set other path while use action on trigger.
–
536 Destination path is same as source path, or sub folder of source path. –
539 Module configuration is not matched, so it couldn’t loaded.
Configuration of saved data can see by File property.
Chapter 6,
1
chapter 8
2
540 Cannot re-save from SD Card recording data. –
541 Cannot detect the medium.
Check the presence of the medium.
–
542 Cannot start SD card recording, because there is not enough free space on the SD card or it is not
installed.
–
544 Cannot file access, Initialize, and autosetup while measure is in progress.
Wait measure end, or OFF it.
3.6, 3.7, 6.10
1
545 Data read error. –
546 Cannot save when subchannel condition was changed.
Restore subchannel condition.
Chapter 2
1
552 There are no items to save with SAVE key. Chapter 6
1
553 There are no waveform types to save. Chapter 2
1
554 File loading completed normally.
However, because the loaded module is different from the current module configuration, the following
channel settings and data are not loaded.
–
576 Printer error. –
577 The length of the print has more than 25 pages.
As will be less than 25 pages, please set the “Print Mag” and “Time Range”.
6.6
1
1 User’s Manual, IM DL350-02EN
2 Features Guide, IM DL350-01EN
5.2 Messages and Corrective Actions
To Next Page
Loading...
Need help?
General
