YOKOGAWA DL350 Getting Started Guide

5-2
IM DL350-03EN
5.2 Messages and Corrective Actions
Messages
Messages may appear on the screen during operation. This section describes the error messages and
how to respond to them. You can display the messages in the language that you specify through the
operations explained in section 20.3 in the User’s Manual.
If servicing is necessary to solve the problem indicated by a message, contact your nearest
YOKOGAWA dealer.
In addition to the following error messages, there are also communications error messages. These
messages are explained in the communication interface user’s manual, IM DL350-17EN.
Information
Code Message Chapter or
Section
51 Autosetup is running. 3.6
53 Initializing is in progress. 3.7
57 Automatic balancing is running… 2.6
1
58 Automatic balancing is complete. 2.6
1
59 Calibration is running... 1.6
1
63 A strain module is installed.
Carry out automatic balancing before use.
–
64 File access is aborted. –
67 Key response time is more than 1 second.
Push it more than 1 second.
20.5
1
70 Exit from GO/NO-GO mode. Chapter 13
1
72 Completed action. Chapter 3
1
73 Aborted the search. Chapter 16
1
74 Executed the search, but no record was found that matched the conditions. Chapter 16
1
75 Executed the search, but no record was found that matched the pattern. Chapter 16
1
77 Aborted the statistical measurement. 8.2
1
80 Input module configuration was changed.
Relevant settings have been initialized.
Chapter 2
1
87 Sensed the firmware version change.
Will initialize.
Chapter 2
1
88 Post processing of SD Card Record.
Wait a while.
–
89 Cannot display XY waveforms under these conditions.
- Different sample rate between X & Y.
- SD Card Recording waves
–
90 Executed the Autosetup, but no effective channel was found. –
91 Some signals were not loaded due to the following problems.
Check the symbol file.
- The Number of signals is too many.
- “Value Type” is not supported.
- “Bit Count” is too many.
–
92 Cannot display some zoom waves while in this condition. –
93 Following sub channel was set to Off due to limit of memory capacity. 2.10,
1
2.11,
1
2.12,
1
94 Executing abort process. It takes a few seconds. 16.1
1
95 Cannot set all sub-channels input to on due to limit of memory capacity. 2.10,
1
2.11,
1
2.12
1
97 Offset cancel value was set to maximum value due to over the limit. 2.2
1
1 User’s Manual, IM DL350-02EN

YOKOGAWA DL350 Specifications

General

Brand	YOKOGAWA
Model	DL350
Category	Recording Equipment
Language	English