110 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
5: Replacement Procedures
Procedures
Tests and Adjustments
Preliminary Setup - Printing preferences
Step 1. Ensure that a YMCKO Ribbon is installed in the printer.
Step 2. Go to Start > Devices and Printers. Right click on the Zebra ZXP Card Printer
listing, and select Printing preferences.
Step 3. The Printing Preferences window will open.
Step 4. Select the Card Setup tab.
Step 5. Set Monochrome Conversion to Barcode.
Step 6. Click the Image Control button.
Step 7. Observe the Image Control window.
Step 8. Ensure that the Black slider is set to 0.
Step 9. Click the Close button to close the Image Control window.
Step 10. Click on the OK button to save the settings and to close the Printing
Preferences window.
Important • To perform the tests and adjustments in this section, you will need a
YMCKO
Ribbon and a Black Monochrome Ribbon.
To Next Page
Loading...
Need help?
General
