G: Upgrade Kit Instructions
P1061942-001 Zebra ZXP Series 1 Card Printer Service Manual 233
Preliminary Steps
Remove the Bottom Cover
Step 1. Turn the printer over, bottom-side up.
Step 2. With a Flat-blade Screwdriver, carefully pry off the four rubber feet (they are held in
place with adhesive). Note that the feet cover access holes to the screws holding the
Bottom Cover in place.
Step 3. With a TORX T10 driver, remove the four bottom-cover screws (arrows above).
Step 4. Remove the Bottom Cover.
To Next Page
Loading...
Need help?
General
