72 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
2: Installation and Setup
Loading Cards
Step 2. Open the card feeder cover.
Step 3. Slide the card guide all the way to the right until it locks in place with an
audible click.
Step 4. Remove the wrapper from the card stack.
Step 5. Examine the cards, and discard any cards with damaged edges.
Step 6. Holding the card stack by its sides, fan the cards (like flexing a deck of playing
cards) at least once from each end, so as to separate all the cards.
Step 7. Restore the card stack to its original squared-off condition.
Step 8. Place the stack of cards into the card feeder.
Step 9. Close the card feeder cover. When card feeder cover is closed, the card guide locking
mechanism will be released automatically.
Caution • Hold the cards by the edges only. DO NOT touch print surfaces as this can
reduce print quality.
To Next Page
Loading...
Need help?
General
