102 Parameters
Terms and abbreviations
Fieldbus addresses
Refer to Fieldbus control through the embedded fieldbus interface (EFB).
Term Definition
Actual signal Signal measured or calculated by the drive. Usually can only be
monitored but not adjusted; some counter-type signals can however be
reset.
Def The default is shown on the same row as the parameter name.
The default value of a parameter for the Factory macro. For information
on other macro-specific parameter values, see chapter Control macros.
FbEq16/32 The fieldbus equivalent for 16-bit and 32-bit. They are shown on the
same row as the parameter range, or for each selection.
A dash (-) indicates that the user cannot access the parameter in 16-bit
format.
32-bit fieldbus equivalent: The scaling between the value shown on the
panel and the integer used in communication when a 32-bit value is
selected for transmission to an external system.
Other The value is taken from another parameter.
Choosing “Other” displays a parameter list in which the user can specify
the source parameter.
Other [bit] The value is taken from a specific bit in another parameter. The user
selects the source from a parameter list.
Parameter Either a user-adjustable operating instruction for the drive, or an Actual
signal.
p.u. Per unit
[parameter number] Value of the parameter
ACS180 FW.book Page 102 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
Need help?
General
