50 Program features
Settings and diagnostics
Parameter 10.22...10.24 RO1 source.
Events: -
Fieldbus control
The drive can be connected to an automation systems through its fieldbus interface.
See chapter Fieldbus control through the embedded fieldbus interface (EFB).
Settings and diagnostics
Parameter group 58 Embedded fieldbus.
Events: -
Motor control
Motor types
The drive supports the following motor types:
• Asynchronous AC induction motors
• Permanent magnet (PM) motors
Settings and diagnostics
Parameter 99.03 Motor type.
Events: -
Motor identification
In scalar motor control mode (99.04), the drive performs no motor identification. The
performance of vector control is based on an accurate motor model determined
during the motor start-up.
A motor Identification magnetization is automatically performed the first time the start
command is given. During this first start-up, the motor is magnetized at zero speed
for several seconds to allow the motor model to be created. This identification method
is suitable for most applications in vector control mode.
In demanding applications a separate Identification run (ID run) can be performed.
Settings and diagnostics
Parameter 99.13 ID run requested (page 294).
Events: -
ACS180 FW.book Page 50 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
Need help?
General
