Program features 99
The parameters included in the checksum B calculation are user editable parameters
in parameter groups 10, 15, 19, 20, 21, 22, 23, 24, 25, 28, 30, 31, 32, 35, 36, 37, 40,
41, 46, 71, 95, 96, and 97.
Settings and diagnostics
Parameters 96.54…96.55, 96.68…96.69 and 96.71…96.72.
Events A686 Checksum mismatch (page 336), B686 Checksum mismatch (page
341) and 6200 Checksum mismatch (page 345).
Events: -
Motor potentiometer
The motor potentiometer is a counter whose value can be adjusted up and down
using two digital signals selected by parameters.
When enabled, the motor potentiometer assumes a set value. Depending on the
mode selected, the motor potentiometer value is either retained or reset over a power
cycle.
The change rate is defined as the time it would take for the value to change from the
minimum to the maximum, or vice versa. If the up and down signals are
simultaneously on, the motor potentiometer value does not change.
The output of the function is shown, and it can be directly set as the reference source
in the main selector parameters, or used as an input by other source selector
parameters.
The following example shows the behavior of the motor potentiometer value.
Settings and diagnostics
Parameters 22.71…22.80.
0
1
0
1
0
22.80
22.74
22.73
22.77
22.76
22.75
ACS180 FW.book Page 99 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
Need help?
General
