ABB ACS180 User Manual

Parameters 291
98.12 SigmaL user SI Defines the leakage inductance L
S
.
Note: This parameter is valid only for asynchronous
motors.
0.00 mH
0.00…100000.00 mH Leakage inductance. 1 = 10000
mH
98.13 Ld user SI Defines the direct axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
0.00 mH
0.00 …100000.00 mH Direct axis inductance. 1 = 10000
mH
98.14 Lq user SI Defines the quadrature axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
0.00 mH
0.00 …100000.00 mH Quadrature axis inductance. 1 = 10000
mH
99
99 Motor data
Motor configuration settings.
99.03 Motor type Selects the motor type.
Note: This parameter cannot be changed while the drive
is running.
Asynchro-
nous motor
Asynchronous motor Standard squirrel cage AC induction motor (asynchronous
induction motor).
0
Permanent magnet
motor
Permanent magnet motor. Three-phase AC synchronous
motor with permanent magnet rotor and sinusoidal
BackEMF voltage.
Note: With permanent magnet motors special attention
must be paid on setting the motor nominal values correctly
in this parameter group (99 Motor data). You must use
vector control. If the nominal BackEMF voltage of the
motor is not available, a full ID run should be performed
for improving performance.
1
99.04 Motor control mode Selects the motor control mode. Scalar
Vector Vector control. Vector control has better accuracy than
scalar control but cannot be used in all situations (see
selection Scalar below).
Requires motor identification run (ID run). See parameter
99.13 ID run requested.
Note: In vector control the drive performs a standstill ID
run at the first start if ID run has not been previously
performed. A new start command is required after
standstill ID run.
Note: To achieve a better motor control performance, you
can perform a normal ID run without load.
See also section Operating modes of the drive (page 46).
0
No. Name/Value Description Default
FbEq 16
ACS180 FW.book Page 291 Tuesday, March 9, 2021 2:25 PM

ABB ACS180 Specifications

General

Brand	ABB
Model	ACS180
Category	DC Drives
Language	English