Introduction to the manual
18
Contents
The chapters of this manual are briefly described below.
Safety instructions give safety instructions for the installation, commissioning,
operation and maintenance of the drive.
Introduction to the manual introduces this manual.
Operation principle and hardware description describes the drive.
Mechanical installation shows how to move and unpack the delivery and how to
fasten the cabinet to the floor.
Planning the electrical installation instructs on the motor and cable selection, the
protections and the cable routing.
Electrical installation instructs how to wire the drive.
Motor control and I/O board (RMIO) shows external control connections to the motor
control and I/O board and its specifications.
Installation checklist and start-up helps in checking the mechanical and electrical
installation of the drive.
Maintenance contains preventive maintenance instructions.
Technical data contains the technical specifications of the drive, eg, the ratings,
sizes and technical requirements, provisions for fulfilling the requirements for CE
and other markings and warranty policy.
Dimensional drawings contains the dimensional drawings of the drive.
Resistor braking describes how to select, protect and wire optional brake choppers
and resistors. The chapter also contains technical data.
To Next Page
Loading...
Need help?
General