Mechanical installation
35
Fastening the cabinet to the floor and roof/wall (marine units)
See ACS800-07/U7 Dimensional Drawings [3AFE64775421 (English)] for the
locations of the fastening holes in the flat bars below the cabinet and for fastening
points at the top of the cabinet. Top fastening brackets are included in the delivery.
Fasten the cabinet to the floor and roof (wall) as follows:
1. Bolt the unit to the floor through the holes in each flat bar at the base of the
cabinet using M10 or M12 screws.
2. If there is not enough room behind the cabinet for installation, clamp the rear ends
of the flat bars.
3. Remove the lifting lugs and bolt the fastening brackets into the lifting lug holes (a).
Fasten the top of the cabinet to the rear wall and/or roof with brackets (b).
Fastening the cabinet at the top with brackets (side view)
Cabinet
M16 bolt
Fastening bracket
Clamping the cabinet to the floor at the back
Back panel of
cabinet
Flat bars at base of cabinet
Clamps
2
1
1
1
IP54 roof
Fastening bracket
3b
3a
3a
3a
3a
To Next Page
Loading...
